Kiwi Premium Wheat Nubuck 6" Water Resistant Work Boots [61100]

A 6-inch wheat nubuck soft toe work boot for men and women, with Goodyear welt construction, for work that calls for a tough, comfortable boot but not a safety toe.

The upper is water-resistant wheat nubuck leather, built to hold up to daily wear on the job site and in bad weather. Dense, precision-stitched seams and a tightly built upper resist water penetration and help keep feet dry in light rain and wet or muddy conditions.

This boot meets ASTM F2892-24 for soft toe footwear and is rated EH [Electrical Hazard] and ASTM F3445-24 SR [Slip Resistant]. It has no protective toe cap, so it gives no impact or compression protection.

Tested to ASTM F2892-24 EH: 18,000 V AC at 60 Hz for 1 minute with no more than 1.0 mA leakage.

Underneath, a Goodyear welt stitches the upper to a heavy-duty GripTrek™ oil resistant rubber lug outsole for traction and stability on a wide range of surfaces. A steel shank runs through the midfoot to support the arch on ladder rungs and uneven ground. Because the sole is stitched on, a cobbler can resole the boots when the tread wears down.

Inside, a breathable mesh lining and an extra-cushioned mesh + PU insole handle comfort and moisture over long shifts. The insole lifts out, so you can fit your own orthotic. 200g 3M™ Thinsulate™ insulation keeps your feet warm on cold mornings without adding bulk, and the breathable lining keeps the boot easy to wear when the weather warms up.

Seven reinforced metal eyelets let you lace the boot as snug or as loose as you like. The padded 6-inch shaft holds the ankle steady and cuts fatigue on long days. Width: D [Standard]. A rear pull tab makes the boots easy to pull on.

Sized in US men's 5 to 12 in half sizes, plus 13, which fits women's 6.5 to 13.5, plus 14.5. The box label shows both sizes.

EH protection is reduced when the boots are wet or as the outsole wears. Do not wear this boot where a protective safety toe is required.